
The procedure is as follows:
1.
Press and hold the Security button on Adapter B for 10 seconds. Release it when the Power light flashes.
The
password to Adapter B has just been erased and removes itself from Adapter A & C.
2.
Press and hold the Security button on Adapter D for 2 seconds.
3.
Within 120 seconds after the Power light on Adapter D starts to flash, press and hold the Security button on
Adapter B for 2 seconds then release.
4.
Adapter B and Adapter D are now connected to each other, which in turn becomes part of Network BDE.
3
Troubleshooting
If your HomePlug AV Ethernet Adapters have difficulty communicating with each other, check the following:
•
Try power cycling the unit by unplugging it from the wall for 10 seconds and plugging it in again.
•
Use a pin and hold the Reset button down for 2 seconds on each unit you are trying to connect. The HomePlug
AV Ethernet Adapter’s light will flash, the units will reset and attempt to link using default factory settings.
•
Try plugging the HomePlug AV Ethernet Adapter into an adjacent plug.
•
HomePlug AV Ethernet Adapters work better when plugged directly into the wall outlet. Connecting these
Ether-
net Adapters to a power strip or surge protector may degrade network performance or completely stop
network
signals.
•
This HomePlug AV Ethernet Adapter should not be used on GFI protected outlets as some outlets will filter
out
HomePlug Powerline signal.
•
This HomePlug AV Ethernet Adapter should not be used in areas with excessive heat.
•
Certain florescent or incandescent lights are noise sources on the electrical and can degrade performance.
•
If your building has more than one circuit breaker box, your HomePlug AV Ethernet Adapters may not be able to
connect between the different circuit breaker boxes. In this case, connect one HomePlug AV Ethernet Adapter
to
a power outlet located on each of the circuit boxes. Connect Ethernet cable between each of the HomePlug
AV
Ethernet Adapters to link the different circuits together. This will allow the HomePlug AV Ethernet Adapters
from
different circuit breaker boxes to connect.
Commentaires sur ces manuels